Concrete Patio Cost: $1,760–$10,000 (Average $3,414) in 2026
Author: CostGuideHQ Editorial·✓ Fact-checked·Updated July 2026·5 min read·3 sources Quick answerQuick answer: A concrete patio typically costs $1,760 to $10,000, averaging around $3,414 nationally. Per square foot, plain concrete runs $4 to $12, while stamped or stained finishes run $8 to $30. Size, finish, thickness, and site prep drive most of the price difference.
- ✓The national average cost for a concrete patio is about $3,414, with most projects falling between $1,760 and $10,000 -- a range that blends Bob Vila's typical low end with Angi's high-end figure for complex or maximum-cost projects (Angi, Bob Vila).
- ✓Plain concrete costs $4 to $12 per square foot, while stamped or stained decorative finishes run $8 to $30 per square foot (HomeGuide, Angi).
- ✓A typical 20x20 ft (400 sq ft) plain concrete patio costs $1,600 to $4,800; the same size in stained or stamped concrete runs $3,200 to $12,000 (HomeGuide).
- ✓Site preparation and grading for an uneven or poorly draining lot adds roughly $1,000 to $3,200 on top of the slab itself (Angi, Bob Vila).
How much does concrete patio cost?
National average
$3,414
total project
Typical range
$1,760–$10,000
Most projects
Whole project
$1,919–$5,393
Advertisement · 728 × 90
Cost by material / type
| Type | Low | High |
|---|
| plain/smooth finish (per sq ft) | $4 | $12 |
| broom finish (per sq ft) | $6 | $13 |
| exposed aggregate (per sq ft) | $7 | $18 |
| epoxy-coated (per sq ft) | $7 | $22 |
| stained (per sq ft) | $8 | $25 |
| stamped (per sq ft) | $9 | $30 |
What affects the cost?
- Patio size and square footage -- larger patios cost more overall but have lower per-square-foot rates (HomeGuide)
- Design complexity -- curved edges, multi-level designs, or custom forms cost more than a plain rectangle (Angi, Bob Vila)
- Finish type -- plain concrete runs $4-$12/sq ft while stamped or stained finishes run $8-$30/sq ft (HomeGuide, Angi)
- Thickness -- standard 3.5-4 inch slabs are typical; thicker 6-inch slabs raise material and labor costs (HomeGuide, Angi)
- Site preparation and grading -- leveling a sloped or poorly drained site adds about $1,000-$3,200 (Angi, Bob Vila)
- Reinforcement -- rebar or wire mesh adds roughly $1-$3 per sq ft but helps prevent cracking (HomeGuide)
- Labor -- contractors typically charge $50-$75 per hour, or about $5-$15 per sq ft (Angi, Bob Vila)
- Permits -- typically $50-$400 depending on local requirements (HomeGuide, Bob Vila)
- Geographic location -- urban areas and regions with higher labor/material costs push prices up (Bob Vila)
Why does a concrete patio cost so much?
Cost mainly comes down to size and finish. A full project typically runs $1,760 to $10,000, averaging around $3,414 nationally (Angi, Bob Vila). That headline range combines Bob Vila’s typical low end with Angi’s reported high end for larger or more complex projects, so most homeowners should expect to land closer to the average than to either edge. Per square foot, plain concrete costs $4 to $12 installed, while decorative finishes like staining or stamping run $8 to $30 per square foot (HomeGuide, Angi). A typical 20x20 ft (400 sq ft) patio illustrates the swing: about $1,600 to $4,800 in plain concrete versus $3,200 to $12,000 for the same footprint in stained or stamped concrete (HomeGuide). Labor makes up a large share of the bill, with contractors charging $50 to $75 per hour, or roughly $5 to $15 per square foot (Angi, Bob Vila). Materials, forming, thickness, and any reinforcement round out the rest of the cost.
What affects the cost?
A few factors explain most of the gap between a $1,800 patio and one that costs $10,000 or more:
- Patio size. Larger patios cost more in total but benefit from lower per-square-foot rates as size increases (HomeGuide).
- Finish type. Plain concrete runs $4-$12 per sq ft; broom finish $6-$13; exposed aggregate $7-$18; epoxy-coated $7-$22; stained $8-$25; and stamped concrete $9-$30 (HomeGuide).
- Design complexity. Curved edges, multi-level designs, or custom forms cost more than a simple rectangular slab (Angi, Bob Vila).
- Thickness. Standard patios run 3.5 to 4 inches thick; heavier 6-inch applications raise material and labor costs (HomeGuide, Angi).
- Site preparation. Grading a sloped, rocky, or poorly draining lot adds about $1,000-$3,200 (Angi, Bob Vila).
- Reinforcement. Rebar or wire mesh adds roughly $1-$3 per sq ft but helps prevent cracking over time (HomeGuide).
- Permits. Local permits typically run $50-$400 depending on the municipality (HomeGuide, Bob Vila).
- Location. Regional labor and material costs push urban-area pricing higher than rural areas (Bob Vila).
How to lower your concrete patio cost
- Stick with plain or broom-finished concrete. These are the most affordable options – plain runs $4-$12 per square foot and broom finish $6-$13 – versus $8-$30 for stained or stamped decorative finishes (HomeGuide).
- Keep the shape simple. A basic rectangular slab avoids the extra forming labor that curves, multiple levels, or custom shapes require (Angi, Bob Vila).
- Get quotes before committing to site work. Since grading and leveling can add $1,000-$3,200, ask contractors up front whether your lot needs significant prep (Angi, Bob Vila).
- Confirm reinforcement needs rather than over-building. Rebar or mesh adds $1-$3 per square foot and is worthwhile for durability, but check what your specific soil and climate actually require (HomeGuide).
- Check permit costs early. They’re a relatively small line item ($50-$400) but can affect your project timeline if overlooked (HomeGuide, Bob Vila).
Prices vary by region, patio size, and finish, so treat the figures above as a planning budget. Get two or three local quotes, and confirm what’s included (site prep, reinforcement, permits, sealing) before comparing bids.
Advertisement · 336 × 280
Frequently asked questions
How much does a concrete patio cost on average?+
Most homeowners pay around $3,414 nationally, with typical projects ranging from $1,760 up to $10,000 for larger or more complex jobs, depending on size and finish (Angi, Bob Vila).
How much is a concrete patio per square foot?+
Plain concrete runs $4 to $12 per square foot installed. Decorative finishes like staining or stamping push that up to $8 to $30 per square foot (HomeGuide, Angi).
What's the cheapest concrete patio finish?+
A plain, smooth trowel finish is the most affordable at $4 to $12 per square foot. Broom finishing, which adds slip resistance, costs only slightly more at $6 to $13 per square foot (HomeGuide).
How much more does a stamped concrete patio cost than plain concrete?+
Stamped concrete costs $9 to $30 per square foot versus $4 to $12 for plain concrete, roughly double to triple the price depending on pattern complexity (HomeGuide).
Does site preparation cost extra?+
Yes. Leveling and grading a sloped or poorly draining site typically adds $1,000 to $3,200 beyond the base cost of the slab (Angi, Bob Vila).
How much does labor cost for a concrete patio?+
Contractors typically charge $50 to $75 per hour, which works out to roughly $5 to $15 per square foot of the total project cost (Angi, Bob Vila).
Sources
Figures synthesized and cross-checked across these sources (retrieved 2026-07-24):
- Angi — Average $3,554; normal range $1,919-$5,393; low end $800; high end $10,000. Overall per sq ft $4-$30. By size: 7x7 (49 sq ft) $400-$1,050; 10x10 (100 sq ft) $600-$1,600; 12x12 (144 sq ft) $850-$2,300; 16x20 (320 sq ft) $1,900-$5,100; 20x20 (400 sq ft) $2,400-$6,400. By finish per sq ft: Stenciled $1-$10; Exposed Aggregate $2-$3; Painted $2-$6; Polished $3-$10; Broom Finish $4-$7; Smooth/Trowel $4-$7; Stained $5-$10; Stamped $5-$15. Thickness 3.5-4 in ~$10/sq ft. Labor $50-$75/hour, ~$5-$15/sq ft. Site prep/grading $1,000-$3,200. Rebar $1.40-$1.85 per 2 ft of material.
- HomeGuide — $4-$12 per sq ft plain concrete; $8-$30 per sq ft stained or stamped concrete. 20x20 ft (400 sq ft) patio: $1,600-$4,800 plain, $3,200-$12,000 stained/stamped. By finish per sq ft: Plain/smooth $4-$12; Broom finish $6-$13; Stained concrete $8-$25; Stamped concrete $9-$30; Exposed aggregate $7-$18; Epoxy-coated $7-$22 (existing slab coating $4-$12). Materials $2-$12/sq ft; Labor $2-$18/sq ft; Total $4-$30/sq ft. Rebar/wire mesh reinforcement adds $1-$3/sq ft. Permits $50-$400.
- Bob Vila — National average $3,274; typical range $1,760-$4,812 (citing Angi and HomeAdvisor data). Plain square/rectangle patio $4-$7 per sq ft; custom designs or complex color patterns up to $30 per sq ft. Labor $50-$75 per hour, roughly $5-$15 per sq ft. Site preparation/grading $1,000-$3,200. Permits typically $50-$300.
National average and typical range are drawn from Angi (average $3,554; normal range $1,919-$5,393; absolute low-high $800-$10,000) and Bob Vila (average $3,274; typical range $1,760-$4,812, citing Angi/HomeAdvisor data). This guide averages the two national figures ($3,554 + $3,274 / 2 = $3,414) and widens the stated headline range to $1,760-$10,000 by combining Bob Vila's typical-range low bound with Angi's absolute high bound -- i.e. the low end reflects a typical/normal project while the high end reflects an outlier/complex project from a different source and statistical category, not a single coherent range from one source. HomeGuide does not publish a single national average but confirms the per-square-foot economics: $4-$12/sq ft for plain concrete and $8-$30/sq ft for stained or stamped concrete, with a 20x20 ft (400 sq ft) patio running $1,600-$4,800 plain or $3,200-$12,000 decorative -- consistent with the per-project figures above. by_type entries are per-square-foot rates (not totals) sourced primarily from HomeGuide's finish-type table, cross-checked against Angi's separate finish table (which reports a similar but not identical spread, e.g. Angi's stamped range is $5-$15/sq ft versus HomeGuide's $9-$30/sq ft -- the wider HomeGuide figures were kept since Bob Vila and Angi both note complex/custom designs can reach $30/sq ft). Figures generally include base materials, forming, and standard installation labor; site prep/grading, reinforcement, and permits are frequently quoted as separate add-ons. HomeGuide's source page returned an HTTP 403 on verification attempt and could not be independently re-confirmed in this update; its figures are retained as originally cited pending future verification, since by_type and the $8-$30 combined figure rest primarily on it. Bob Vila was independently re-verified and checked out.